Serial to Ethernet Connector [Full sources]

Serial to Ethernet Connector is the software-based solution that allows you to share up to 255 serial port devices
over TCP/IP network turning your computer into low-cost terminal server. As the result, any serial port device
connected to COM port could be accessed from anywhere in the world as if it is attached to local PC. Formerly known as VSPD.Net
Serial to Ethernet Connector has completely new interface and greatly revamped engine. It provides the ability to create
three different types of connection:

• Port-to-port connection, which lets you connect two computers over TCP/IP network. In this way you can emulate virtual
  null-modem cable connection.
  Serial to Ethernet Connector allows you to customize remote serial port settings locally or dynamically fetch these
  settings from the remote end. With Serial to Ethernet Connector you are no longer restricted by null-modem cable length and
  can establish direct connection with virtually every PC over the world


• Port-to-TCP client, which allows you to connect to remote server and send/receive communication serial data over TCP/IP network.
  All that you have to do is specify remote server's IP address or network name and TCP port to connect to and open local COM port.
  Once connection is established, all
  data sent from remote serial port device, attached to the server, will be genuinely delivered to local serial
  port where it can be further processed


• Port-to-TCP server: you will find it indispensable to establish multiple connections to local serial port
  device and redistribute COM port device data all over the world. Server listens to all incoming connections at the defined TCP port
  and redirects input/output serial data
  to TCP/IP network. You may specify TCP port to listen to, COM port and TCP port access rights, etc.
  Server could be configured to start automa